LW100 L4-2.2L VIN F (2002)
5.
Drive out brake pad retaining pins from outside-to-inside, remove pins and retaining springs.
6.
Inspect brake pad retaining pins for deterioration or damage. If damaged, replace.
7.
Apply small amount of silicone grease to retaining pins.
IMPORTANT:
Check to ensure brake pads move freely in guide.
8.
Install new brake pad retaining spring on both sides of vehicle.
9.
Install brake pad retaining pins by driving them from inside outward.
NOTICE:
Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts to loosen in
service.
10.
Position wheel and tire assembly onto hub.
11.
Install wheel bolts and tighten in a crisscross pattern.
11.1 Hand tighten all five wheel bolts.
11.2 Use a torque wrench to tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 N.m (46 ft-lbs)
11.3 Use a torque wrench to final tighten wheel bolts using a crisscross pattern.