LW100 L4-2.2L VIN F (2002)
7. Install caliper retention spring.
8. Re-attach brake hose to strut assembly and install lock plate.
9. Repeat steps I through 7 for opposite side of vehicle.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
10. Position wheel onto hub.
11. Install wheel bolts and tighten in a crisscross pattern.
11.1
Hand tighten all five wheel bolts.
11.2
Use a torque wrench to tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
11.3
Use a torque wrench to final tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
12. Lower vehicle from hoist.
CAUTION: IF THIS OPERATION IS NOT CARRIED OUT, BRAKES WILL NOT OPERATE PROPERLY DURING INITIAL BRAKE
APPLICATIONS.
13. Prior to operating vehicle, depress the brake pedal a few times until brake pads are seated against rotor.
