LW100 L4-2.2L VIN F (2002)
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
5. Position wheel and tire assembly onto hub.
6. Install wheel bolts and tighten in a crisscross pattern.
6.1
Hand tighten all five wheel bolts.
6.2
Use a torque wrench to tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
6.3
Use a torque wrench to final tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
7. Lower vehicle from hoist.
8. Program EBTCM with correct engine and transaxle options or DID CO551 will set and traction control will not operate.