LW100 L4-2.2L VIN F (2002)
Camshaft Bearing: Specifications
L61 ENGINE TORQUE SPECIFICATIONS
Camshaft Bearing Cap Bolts ................................................................................................................................................................. 10 Nm (89 inch lbs.)
Intake Camshaft Rear Bearing Cap Bolts ................................................................................................................................................. 25 Nm (18 ft. lbs.)
Tightening Sequence
Camshaft Bearing Caps
-
Install camshaft bearing caps in correct order and hand start camshaft cap bolts.
-
The timing chain sprocket alignment notch on the camshaft should be oriented to the eleven o'clock position.
-
Tighten camshaft bearing cap bolts in increments of three turns until they are seated.
-
Camshaft Bearing Cap Bolts: 10 Nm (89 inch lbs.)
-
Apply a 5 mm (13/64 inch) bead of Loctite Anaerobic Gasket Maker 518- to rear intake camshaft bearing cap.
-
Install rear intake camshaft bearing cap bolts.
-
Intake Camshaft Rear Bearing Cap Bolts: 25 Nm (18 ft. lbs.)