LW100 L4-2.2L VIN F (2002)
15. Remove connector duct retaining screw.
16. Pull connector duct downward and then rearward to remove from HVAC module.
17. Enable SIR. (Refer to "Enabling the SIR System" procedure.)
INSTALLATION
1. Disable SIR. (Refer to "Disabling the SIR System" procedure.)
2. Push connector duct adapters completely up Onto main duct.
3. Install connector duct onto HVAC module.
4. Install connector duct to HVAC module screw.
Torque:
HVAC Center Duct-to-HVAC Module Fastener: 1 N.m (9 in-lbs)
5. Pull both legs of connector duct down to seal against the left and right rear seat heater ducts.
6. Install I/P bracket.