LW100 L4-2.2L VIN F (2002)
10. Disconnect EVAP canister hose.
11. Loosen fuel filler pipe hose clamp closest to fuel tank.
12. Disengage filler pipe hose from fuel tank and remove fuel filler pipe.
INSTALLATION
1. Raise vehicle to comfortable working height.
IMPORTANT: To ease installation, lightly wipe outside of fuel tank inlet connector with plain water.
2. Position filler pipe into wheel opening with top of pipe within body panel opening.
3. Install fuel filler pipe into fuel tank opening.
IMPORTANT: Ensure that the EVAP vent solenoid pipe is installed in position on the filler pipe bracket.
4. Loosely install filler pipe lower bracket attachment screw but do not tighten.
5. Lower vehicle and install filler pipe upper bracket attachment screw.
Torque:
Fuel Fill Pipe-to-Body (Upper): 2.5 N.m (22 in-lbs)
6. Install rubber closeout grommet to body and filler pipe.
7. Install fuel cap.
8. Raise vehicle to comfortable working height.
NOTE: Ensure that the fuel pipe connecting hose is installed until it touches the fuel tank body. The hose clamp should be located within 6 mm (1/4
in.) of the end of the connecting hose.