LW100 L4-2.2L VIN F (2002)
4. Working from the rear of vehicle forward, install retaining tabs to structure to hold inflator assembly to vehicle. The stripe on the inflator module
should be used as a guide to ensure inflator is not twisted.
5. Install inflator fasteners and torque fasteners.
Torque:
Curtain Inflator Retaining Bolt (10 mm Hex Head): 10 N.m (89 in-lbs)
Torque:
Curtain Inflator Retaining Nut (10 mm Hex Head): 10 N.m (89 in-lbs)
Torque:
Curtain Inflator Retaining Screw (7 mm Hex Head): 2.5 N.m (22 in-lbs)
6. Install headliner and garnish moldings.
7. Enable the SIR system. Refer to Air Bag(s) Arming and Disarming.