LW2 V6-3.0L VIN R (2000)
a. Position carpet retainer into vehicle.
b. Starting at rear of vehicle, slide carpet retainer under rear seat cushion.
c. Position carpet retainer over remaining attaching clip locations.
d. Gently push on attaching clips to install carpet retainer.
e. Install weatherstrip over carpet retainer using a flat blade tool.
CAUTION: MAKE SURE THAT REAR SEAT SHOULDER BELT IS NOT CAUGHT BEHIND BOLSTER WHEN INSTALLING
BOLSTER.
IMPORTANT: If leather rear seat cushion was removed, install it after installing right rear seat bolster.
65. Install right rear seat cushion bolster.
a. Position rear seat bolster onto upper bolster attachment.
b. Push down on bolster to engage upper attachment and install over retaining tab.
c. Bend lower retainer tab over bolster wire frame at rear seat cushion location.
IMPORTANT: If the vehicle is a sedan, proceed to step 68.
66. Wagon only: Install rear load floor.
a. Drill load floor right side-wing rivets out and remove right side-wing.
b. Flip left side-wing (if present) upwards.
c. Place load floor into vehicle.
d. Lift load floor upwards.
e. Slide load floor tabs into front load floor assembly.