LW2 V6-3.0L VIN R (2000)
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel bolts to loosen in service.
5. Position wheel and tire assembly onto hub.
6. Install wheel bolts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
Torque: 125 Nm (92 ft. lbs.)
7. Lower vehicle from hoist.
8. Program EBTCM with correct engine and transaxle options or DTC C0551 will set and traction control will not operate.