LW2 V6-3.0L VIN R (2000)
4.
Remove applicable switch from bracket by rotating 90 degrees.
NOTICE:
The notch on the plunger will be fully visible when the plunger is fully extended.
NOTICE:
If switch plunger separates from switch body, do not attempt to re-insert plunger into switch body. Switch must be replaced.
NOTICE:
Do not attempt to adjust switch more than three times. Multiple adjustments of the switch will cause excessive wear on the adjustment mechanism
within the switch. If switch has been adjusted more than three times replace the switch.
5.
Fully extend plunger from switch housing (may require moderate force) to prepare switch for adjustment.
