LW2 V6-3.0L VIN R (2000)
3. Apply a small amount of Loctite (R) 573 (or equivalent) on forward edge of front bearing caps to ensure an adequate seal between bearing cap and
cylinder head.
4. The bearing caps for front (CYL 2, 4, 6) cylinder head are marked R1-R8 (Cylinders 2, 4, 6).
5. Install camshaft bearing caps in their appropriate position.
6. Install camshaft bearing cap bolts.
IMPORTANT: DO NOT allow the sealer to get into the oil journal of cap.
Note: Tighten camshaft bearing cap bolts starting from center cap gradually.
-
Torque: 8 Nm (71 ft. lbs.)
