LW2 V6-3.0L VIN R (2000)
Torque: 1 N.m (9 in-lbs)
19. Install blower motor assembly into module housing. Fan motor assembly rib must be located into channel in module housing.
20. Connect blower motor electrical connector.
21. Install blower motor housing. Housing rib must fit into slot in module case. Snap left and right clip into place and install fan housing to module
screws.
Torque: 1 N.m (9 in-lbs)
NOTE: A new filter housing seal must be used whenever the filter housing is removed to prevent water from leaking into module.
22. Remove filter housing seal using a small flat blade screwdriver.
23. Install new filter housing seal.