LW2 V6-3.0L VIN R (2000)
27. Install blower motor assembly into module housing. Blower motor assembly rib must fit into channel in housing.
28. Connect blower motor electrical connector.
29. Install blower motor housing. Housing rib must fit into slot in case. Snap left and right clips into place and install screws.
Torque: 1.0 N.m (9 in-lbs)
30. Install connector duct to HVAC module and install screw.
Torque: 1.0 N.m (9 in-lbs)
31. Install lower insulator into forward edge of case then stretch to hook on barbs.