LW2 V6-3.0L VIN R (2000)
INSTALLATION
1. Guide control cable through pass-through in dash panel.
2. Secure control cable grommet by pressing the cable into pass-through hole in dash panel.
3. Route control cable through cable bracket on powertrain mount, and secure cable into bracket.
4. Install control cable retaining clip.
5. Connect control cable end to control assembly lever.
6. Connect control cable to pin on control assembly.
7. Secure control cable into control assembly by pushing into place.
8. Install control cable retaining clip.
9. Install console.
10. Adjust control cable assembly.
11. Enable the Restraint Systems.