LW2 V6-3.0L VIN R (2000)
Wiper Motor: Service and Repair
Wiper Motor Assembly - Rear
REMOVAL
1. Remove rear wiper arm finish cap.
2. Remove wiper arm retaining nut, washer and arm.
3. Remove spacer, shaft nut, washer, and bezel.
4. Open liftgate.
5. Remove liftgate trim panel.
6. Disconnect electrical connector.
7. While supporting rear wiper motor assembly remove mounting bolts.
8. Remove wiper motor assembly.
INSTALLATION
1. Install wiper motor assembly.
2. While supporting rear wiper motor assembly install mounting bolts.
Torque: 3 N.m (27 in-lbs)
3. Connect electrical connector.
4. Install bezel, washer, shaft nut, and spacer.
Torque: 2 N.m (18 in-lbs)