LW200 L4-2.2L VIN F (2003)
6. Install the adjuster lever with the spring.
Important: Check that the brake shoe is correctly engaged in the wheel cylinder at the top and the anchor at the bottom.
Important: Check that the adjuster notches properly engage in the brake shoe notches.
7. Install the retaining bracket and install the upper return spring.
8. Adjust the drum brake shoes. Refer to: See: Brake Drum/Service and Repair/Drum Brake Adjustment
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
9. Install the brake drum and the retaining screw.
Tighten
Tighten the brake drum retaining fastener to 4 Nm (35 lb in).
Notice: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel nuts to loosen in service.
10. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Lower the vehicle from the hoist.
Caution: Prior to operating vehicle, depress brake a few times. If this operation is not carried out, brakes will not operate during initial brake