LW200 L4-2.2L VIN F (2003)
8. Install caliper retaining spring.
NOTICE: Be sure that front brake hose is routed properly. Be careful not to install front brake hose with a twist. Incorrect front brake hose
installation could result in brake failure.
9. Connect brake hose to caliper using new washers.
Torque:
Brake Hose-to-Caliper (use new washer): 40 Nm (30 ft. lbs.)
10. Bleed brakes
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors. Failure to do so can cause wheel bolts
to loosen in service.
11. Position wheel and tire assembly onto hub.
12. Install wheel bolts and tighten in a crisscross pattern.
12.1
Hand tighten all five wheel bolts.
12.2
Use a torque wrench to tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
12.3
Use a torque wrench to final tighten wheel bolts using a crisscross pattern.
Torque:
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
13. Lower vehicle from hoist.