LW200 L4-2.2L VIN F (2003)
Wheel Bearing: Service and Repair
Wheel Bearing/Hub Disassembly
WHEEL BEARING/HUB DISASSEMBLY
^
TOOLS REQUIRED
-
J44563 Front Wheel Bearing Remover/Installer
-
SA9159S Front Wheel Bearing Remover/Installer
NOTICE: If hub or bearing is removed from the knuckle, a new bearing must be used during assembly.
1. Assemble Front Wheel Bearing Remover/Installer SA9159S (or equivalent) with part numbers:
1 - Hub driver
2 - Hub driver screw
3 - Bridge retainer
4 - Bridge
2. Secure entire setup in a vice (by bridge) as shown in illustration.
3. While holding hub driver with a wrench, tighten hub driver screw to extract hub.