LW200 L4-2.2L VIN F (2003)
17. Connect O2 sensor electrical connector and reattach harness to frame.
CAUTION: BEFORE INSTALLING WHEELS, REMOVE RUST OR CORROSION FROM WHEEL MOUNTING SURFACES AND
BRAKE ROTORS. FAILURE TO DO SO CAN CAUSE WHEEL BOLTS TO LOOSEN IN SERVICE.
18. Install wheel and tire assemblies onto hub.
19. Install wheel bolts and tighten in a cries-cross pattern.
19.1 Hand tighten all five wheel bolts.
19.2 Use a torque wrench to tighten wheel bolts using a criss-cross pattern.
Torque:
Wheel Bolts (Initial Torque): 63 Nm (46 ft. lbs.)
19.3 Use a torque wrench to final tighten wheel bolts using a cries-cross pattern.
Torque:
Wheel Bolts (Final Torque): 125 Nm (92 ft. lbs.)
20. Lower vehicle.
21. Install remaining rear transaxle mount-to-frame bolts.
Torque:
Transaxle Mount (Rear)-to-Frame Assembly Bolts: 60 Nm (44 ft. lbs.)
22. Install rear powertrain mount through bolt.
Torque:
Transaxle Mount (Rear) Through Bolts: 90 Nm (66 ft. lbs.)