LW200 L4-2.2L VIN F (2003)
Seals and Gaskets: Service and Repair
Right Side Axle Seal
RIGHT SIDE AXLE SEAL
TOOLS REQUIRED
-
J41102 Axle Seal Installer
REMOVAL
1. Remove stub axle shaft from transaxle.
NOTICE: Be careful not to damage case bore with screwdriver.
2. Use a screwdriver to remove axle seal from case. If necessary, crush seal first in order to loosen seal from case.
INSTALLATION
IMPORTANT: Axle Seal Installer J41102 must be used in order to install seal correctly. The J41102-1 Axle Seal Installing Driver installs axle seal
to a given depth.
1. Using J41102-1 Axle Seal Installing Driver, install a new right side axle seal into the transaxle case.
NOTICE: In order to prevent damage to shaft splines during vehicle operation, add grease (PIN 7847638) to splines on stub shaft.