LW200 L4-2.2L VIN F (2003)
Quarter Window Glass: Removal and Replacement
Quarter Window Replacement (Wagon)
Tools Required
*
J 24402-A Glass Sealant Cold Knife Remover
*
J 39032 Stationary Glass Removal Tool
*
J 25070 Heat Gun
*
Urethane Adhesive Kit GM P/N 12346392 or Equivalent
*
Isopropyl Alcohol or Equivalent
*
Cartridge-type Caulking Gun
*
Commercial-type Utility Knife
*
Razor Blade Scraper
*
Suction Cups
*
Plastic Paddle
Removal Procedure
Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces
and the interior trim.
1. Remove the rear upper garnish molding. Refer to Garnish Molding Replacement - Rear Upper (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair/Garnish Molding Replacement - Rear Upper) in Interior Trim.
2. Use J 24402-A , J 39032 or equivalent in order to remove the window.
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
Important: Keep the cutting edge of the tool against the window.
3. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinch-weld flange.
*
The only suitable lubrication is clear water.
4. Remove the quarter window from the pinch-weld flange.
Installation Procedure