SC2 L4-1.9L DOHC VIN 7 (1996)
PROTECT YOURSELF BY WEARING SAFETY GLASSES WHEN PERFORMING THIS PROCEDURE.
3.
Thoroughly clean the upper engine mount assembly front cover stud holes using a 10 mm x 1.5 tap. Use compressed air to remove particles from
the holes.
NOTICE:
To prevent damage to the front cover when upper engine mount assembly front cover studs are installed, do not over apply Loctite(R) 242
Threadlocker or equivalent; do not allow Loctite(R) Threadlocker or equivalent to accumulate in the bottoms of the stud holds.
4.
Apply Loctite(R) 242 Threadlocker (P/N 21485277) or equivalent to six to eight middle threads of the upper engine mount assembly front cover
studs.
5.
Install upper engine mount assembly front cover studs into engine front cover.
Torque: 25 N.m (18 ft-lbs)
PARTS REQUIREMENTS:
21012185
Mount Asm-Eng (1st Design)
21012864
Mount Asm-Eng (2nd Design)
21007585
Studs-Eng Mt (2nd Design)
21485277
Threadlocker - Loctite(R) 242
21007127
Cleaner - Choke Aerosol
21007432
Cleaner - Brake and Choke