Sky L4-2.4L (2007)
Important: Do NOT top coat the bonding surface of the rear bar. Use primer only on bonding surfaces. Refer to the adhesive
manufacturer's recommendations.
6. Clean and prepare all bonding and mating surfaces according to the adhesive manufacturer's recommendations.
7. Apply a consistent bead of structural adhesive to the top impact bar (1) to bond the rear compartment panel. Refer to Sheet Molded Compound
(SMC) Panel Bonding.
8. Apply the sealers and anti-corrosion materials to the repair area. Refer to Anti-Corrosion Treatment and Repair.
9. Use the original cut-out piece to patch the access hole.
10. Apply adhesive bonding material as necessary to the repair area of the floor and the patch. Refer to Sheet Molded Compound (SMC) Panel
Bonding.
11. Position the patch and press firmly into place.
Important: A leak proof seal is necessary so that exhaust and fuel fumes cannot enter the vehicle.