Sky L4-2.4L (2007)
3. Rotate the transmission 90 degrees.
4. Measure from the bottom to the face of the output shaft. Record this as dimension B.
5. Install the input and reaction carrier washer (22).
6. Install the input and reaction carrier thrust bearing (23) onto the extension housing.
7. Install the extension housing gasket (25) onto the extension housing (27).
8. Install the extension housing (27) onto the case.
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the extension housing bolts (35).
Tighten the extension housing bolts to 22 N.m (16 lb ft).
Notice: Install the seal onto the tool before installing into the case to prevent damage to the seal.