SL L4-1.9L SOHC VIN 8 (1997)
3. Remove the right side splash shield.
a. Remove two push pins.
b. Remove lower shield to cradle molded-in fasteners at cradle by gently prying at three fastener locations.
IMPORTANT: Remove rear section of shield first, then front
IMPORTANT: If molded-in fasteners are damaged or broken, drill out with a 5/16 bit and replace with a push pin.
4. Remove the engine strut-to-engine bracket and engine strut-to-cradle bracket fasteners.
5. Remove the four engine bracket-to-engine fasteners and remove the engine bracket.
Installation