SL L4-1.9L SOHC VIN 8 (1997)
Crankshaft Position Sensor: Service and Repair
Removal and Installation
Crankshaft Position Sensor.
REMOVAL
1. Record preset radio stations.
2. Turn ignition switch off.
3. Disconnect negative battery cable.
CAUTION: MAKE SURE THE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED PRIOR TO LIFTING.
4. Jack or raise vehicle.
5. Disconnect electrical connector from CKP sensor.
6. Remove attachment bolt and CKP sensor.
INSTALLATION
Crankshaft Position Sensor.
1. Lubricate O-ring with clean engine oil.
2. Install CKP sensor in engine block.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or