SL2 L4-1.9L DOHC VIN 7 (1997)
CAUTION:
MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED PRIOR TO LIFTING. TO HELP AVOID PERSONAL
INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM
WHICH COMPONENTS ARE BEING REMOVED. ENSURE HOIST DOES NOT CONTACT FUEL OR BRAKE LINES.
1.
Raise vehicle on a hoist.
2.
Check the HVAC module drain for blockage. If necessary, clear drain hole with a soft blunt tool such as the eraser end of a pencil.
3.
Lower vehicle.
4.
Inspect for gaps between air inlet grill panel foam and base of windshield.
^
If gaps are present, remove cowl panel and install Kent Industries Adhesive Back Shim Stock (P/N 40115), or equivalent 3 mm X 9.5 mm
(5/16 in. X 3/8 in.) foam. Refer to the appropriate model year service manual for removal and installation procedures.
-
On 1991 - 1999 vehicles, refer to Body Repair Service Manual.
-
On 2000 - 2001 vehicles, refer to S-Series Body/Electrical Volume / Service Manual.
^
If no gaps are present, continue to next step.
5.
Inspect both plenum drains for blockage. Clean with mild soap and water if necessary.
1991 - 1996 SHOWN