SL2 L4-1.9L DOHC VIN 7 (1997)
6. If inner race of bearing is pulled out with the hub in previous step, remove race from hub using part numbers:
-
8-Inner race puller
-
9-Two bridge retainer plates
-
10-Two bolts
-
11-Two flat washers
Inspect hub at bearing location for pitting, scoring, wear, or corrosion. Replace if necessary.
7. Remove steering knuckle from vice.
8. Remove bridge retainer and bridge.
9. Remove bearing retainer snap ring.
Fig. 6 Bearing Removal
10. Place knuckle/bearing assembly in a shop press as shown in illustration, using part numbers:
-
5-knuckle support tube
-
7-small driver
11. Press out bearing. Inspect bore of knuckle for pitting, scoring wear, or corrosion. If damage cannot be easily cleaned up with light sanding, replace
the knuckle.