SW L4-1.9L DOHC VIN 7 (1993)
1997 - 1999 Coupes
20.
Align handle to decklid sheet metal as shown on appropriate model year illustration shown.
21.
Using the release handle as a template, mark one hole location on decklid sheet metal.
NOTICE:
If drill bit is allowed to drill into sheet metal at a depth greater than 6.5 mm (1/4 in.), outer surface of exterior panel may be penetrated.
IMPORTANT:
Due to stiffness of cable conduit, it may be necessary to pre-bend cable conduit prior to handle installation.