SW L4-1.9L DOHC VIN 7 (1993)
IMPORTANT:
The measurement procedure in step 2 of this procedure can be used to measure sag on both first and second design engine mounts. However, the
measurement procedure in step 3 can only be used for the second design mount.
2.
Using two 150 mm (6 in.) scales or a 150 mm (6 in.) scale and a suitable straight edge, measure engine mount assembly as shown in the First
Design Mount illustration.
^
If measurement is equal to or less than 39 mm (1-17/32 in.), proceed to "Engine Mount Assembly Removal Procedure" in this bulletin and
replace engine mount assembly.
^
If measurement is greater than 39 mm (1-17/32 in.), engine mount assembly does not require replacement.
3.
Measure gap in mount at location shown in the Second Design Mount illustration. A 2 mm (5/64 in.) allen wrench or hex key can be used as a
go/no go gauge for this measurement.
^
If tool does not fit in gap, proceed to "Engine Mount Assembly Removal Procedure" in this bulletin and replace engine mount assembly.
^
If tool fits in gap, engine mount assembly does not require replacement.
Engine Mount Assembly Removal Procedure