SW L4-1.9L DOHC VIN 7 (1993)
5.
Position new upper control valvebody assembly onto spacer plate (and check balls), and install the one bolt holding the two halves of the
valvebody together.
IMPORTANT:
The dowel bolts must be placed in the holes shown to align the upper valvebody to the lower valvebody.
Torque: 11 Nm (97 in-lbs)
6.
Lube actuator 0-rings.
7.
Install actuators using a twisting motion.
8.
Check connector plate terminals with a # 43 (2.25 mm) drill bit. There should be a slight drag on the shank. If there is no drag, replace the
connector plate.