SW L4-1.9L DOHC VIN 7 (1993)
4. Position door handle assembly in trim panel.
Tip handle outward at top.
Using a thin hook style tool, lift latch and lock rods into retainers and engage retainer clamps.
Push handle into trim panel and slide rearward to engage tabs.
Install screw in handle. Tighten screws.
5. Connect harness to power door lock switch, if equipped. Install switch into handle assembly.
6. Install inner belt sealing strip.
7. Install mirror trim panel with screws. Tighten screws.
Power Windows
NOTE: This article has been updated with TSB# 94-T-53.
A design change was made to the front door side window regulator assembly installed on vehicles built after and including VIN SZ148736. Since the
2nd design regulator installs differently, the inner door panel has also been revised. This article describes the installation procedure to install a new 2nd
design regulator into a 1st design door.
1. Remove inner and outer door trim panels.
2. Lower door glass. Remove front side door window regulator nuts with tool SA9148B.
Push glass up and rotate slightly.
Remove door glass.
3. On vehicles equipped with a power front side door window regulator, disconnect electrical harness connector.
4. Remove front side door window regulator assembly cam bolts.
Drill out rivets and remove front side door window regulator assembly.