SW1 L4-1.9L SOHC VIN 8 (1996)
5.
Remove the old door insert from the door trim panel.
6.
Remove any heat stake material that may be left in the door trim panel holes, or on the door trim panel substrate.
Rear Interior Door Trim Panel/Installation
1.
Center the new door insert on the door trim panel substrate.
2.
Place the door trim panel assembly back on the cloth type protective material with the heat stake side up.
3.
Place one hand on the front side of the door trim panel (the side that is on the work bench) at one of the door insert corners. Press and hold the
door insert heat stake against the door trim panel substrate.
IMPORTANT:
A desirable round heat stake weld should have an approximate diameter of 10 mm (13/32 in.) and 2 mm (3/32 in.) high. A desirable rectangular heat
stake weld should be approximately 13 mm (1/2 in.) long, 5 mm (13/64 in.) wide and 5 mm (13/64 in.) high.
