SW1 L4-1.9L SOHC VIN 8 (1996)
2.
Place the door trim panel (heat staked side up) on a work bench with a cloth type material to protect the panel's finish.
IMPORTANT:
Drill into the heat staked stud just enough to cause the stud material to separate from the substrate (door trim panel) material.
3.
Using a 7 mm (9/32 in.) drill bit, drill out the round heat staked studs.
4.
Remove the rectangle shaped heat stakes with a hand grinder (die grinder) using a 38 mm (1.25 in.) diameter grinding disk, or equivalent, by
grinding the studs from the side.