SW1 L4-1.9L SOHC VIN 8 (1996)
13.
Remove upper (white liner) cone array.
14.
Install 3M(R) Electrical Moisture Sealant Patches (P/N 06149) or equivalent over the 25 x 25 mm upper rear trim panel attachment hole and the
25 x 30 mm access hole located directly above it in the inner door structure. (Holes are located in the inner door where the upper [white liner] cone
array was removed from.)
15.
If the vehicle was built before and includes VIN TZ243340, remove the upper rear attachment hook using a utility knife or fine saw blade.
On vehicles built after and including VIN TZ243341, the attachment hook is no longer present.
16.
Water test vehicle to verify repair.
CAUTION:
IF ENERGY ABSORBING FOAM IS REMOVED FROM DOOR, IT MUST BE REPLACED WITH A NEW PART. IF OMITTED FROM THE
DOOR, THE VEHICLE WILL NOT MEET FEDERAL MOTOR VEHICLE SAFETY STANDARDS (FMVSS), SUBJECTING THE RETAILER