SW1 L4-1.9L SOHC VIN 8 (1996)
4.
Trim a 114.3 x 298.5 mm (4-1/2 x 11-3/4 in.) rectangle piece from a new battery heat shield assembly (P/N 21024475).
5.
Apply a generous amount of Kent Industries Stick It Adhesive (P/N 10170) or equivalent to the back side of the foam piece cut from the battery
heat shield assembly. (The back side of the foam is the side opposite the smooth side.)
6.
Apply a generous amount of Kent Industries Stick It Adhesive (P/N 10170) or equivalent to the A/C compressor suction hose conduit.
7.
Allow enough time for the adhesive to flash, then install foam piece to A/C compressor suction hose conduit.
IMPORTANT:
When installing the foam piece to the A/C compressor suction hose conduit, make sure to align the edge of the foam piece to the lengthwise opening
in the A/C compressor suction hose conduit as shown in illustration.
8.
Trim foam piece as required to fit the length of the A/C compressor suction hose.
9.
Lubricate the A/C compressor suction hose with a mild liquid soap to help installation of the A/C compressor suction hose conduit.
NOTICE:
Make sure the A/C compressor suction hose conduit does not contact transaxle electrical wires, or transaxle electrical wire could become damaged.
10.
Install the A/C compressor suction hose conduit to the A/C compressor suction hose. Position the A/C compressor suction hose conduit just
rearward of the transaxil wire connector. Make sure A/C suction hose conduit does not contact transaxle wires.
11.
Reconnect front air intake duct assembly to air filter assembly.
PARTS REQUIREMENTS:
21024475
Shield Asm-Batt Ht
CLAIM INFORMATION:
