SW1 L4-1.9L SOHC VIN 8 (1996)
Important: Never replace brake pads on one side of axle only. Left and right side brake parts must be replaced only as a axle set.
1. Using a C-clamp, bottom the piston all the way into the caliper bore.
2. Lift inner edge of piston boot to release any trapped air.
Important: Boot must lie flat, below the level of the piston face.
3. Install new pad clips into caliper support.
Important: Remove all rust and corrosion from the caliper brackets and the spring clips when installing brake pads. If installing used brake pads,
remove all rust and corrosion from the ends of the brake pads and from the notch. Using a small amount of silicone grease, lubricate both the caliper
brackets behind the spring clips and the spring-clip-to-brake-pad interfaces. Make sure the brake pads move freely in the caliper brackets when the
brakes are assembled.
4. Install inner and outer brake pads into caliper support.
