SW1 L4-1.9L SOHC VIN 8 (1996)
CAUTION: Be careful not to bend brake lines.
2. Position brake lines into the master cylinder and secure brake line fitting nuts.
^
Torque to 32 Nm (24 ft. lbs.)
3. Install electrical connector for brake fluid level sensor switch.
4. Connect negative battery cable.
5. Fill brake fluid reservoir with clean brake fluid up to the base of the reservoir fill neck.
6. Bleed brake system. See: Service and Repair
7. Check brake fluid level.
8. Check for leaks with engine running and brakes applied.
