SW1 L4-1.9L SOHC VIN 8 (1996)
21.
Make sure the battery cable ends are clean.
22.
Make sure that the battery is in good physical condition (e.g., no cracks, or obvious damage) and that the terminals are clean.
23.
Install battery carefully in the battery tray; make sure that the terminals do not short against any metal during the installation.
24.
Install the battery hold-down retainer, locking the battery into the battery tray. Install and tighten the hold-down retainer nut and screw.
Torque: 9 N.m (80 in-lbs)
25.
Install the positive battery cable first.
Torque: 17 N.m (151 in-lbs)
26.
Install the negative battery cable last.
Torque: 17 N.m (151 in-lbs)
27.
Install air induction system.
IMPORTANT:
It may be necessary to use a 2 mm thick shim between the forward mounting foot on the air cleaner assembly and the midrail.
28.
Road test vehicle to verify that vibration has been repaired.
