SW1 L4-1.9L SOHC VIN 8 (1996)
the rearward horizontal battery tray fastener. (This is called the Second design.)
On 1995 vehicles built after and including VIN SZ154031 and 1996-1999 vehicles, a reinforcing bracket attached to the rear horizontal battery tray
fastener helps support the battery tray. The procedure to install the powertrain damper kit differs if the vehicle has one or two horizontal battery tray
fasteners.
Damper Bench Assembly to Lower Bracket
(Required for all vehicles)
1.
Remove the first rubber grommet and the first steel washer from the damper shaft.
2.
Install the damper shaft into the appropriate lower bracket; install the rubber grommet and then the steel washer onto the damper shaft.
3.
Install the M6 nut to the damper shaft. To tighten the nut, hold the "flats" on the damper shaft with a 7 mm wrench.
Torque: 10 N.m (89 in-lbs)
4.
After damper is assembled, proceed to "Battery and Battery Tray Removal."
Battery and Battery Tray Removal
(Required for all vehicles)
1.
Remove air induction system.
