SW1 L4-1.9L SOHC VIN 8 (1996)
Check for Preloaded Engine Strut Cradle Bracket
Loosen the two engine strut bracket-to-cradle fasteners and check the powertrain for binding by pushing forward and rearward on the engine oil pan. The
powertrain should travel a minimum of 3.18 mm (1/8 in.).
If the powertrain does not move, perform the following procedure:
1.
Check the engine and transaxle struts for correct installation and bushing wear.
2.
Check the engine strut bracket-to-cradle fasteners. Refer to "Engine Strut" procedure in the "Powertrain Mounts" section of the "Chassis Service
Manual."
3.
Shake the powertrain by pushing forward and rearward on the engine oil pan.
4.
Allow the powertrain to settle to its natural position; tighten the two engine strut bracket-to-cradle fasteners.
Torque: 50 N-m (37 ft-lbs)
IMPORTANT:
Make sure the engine strut bracket does not move forward or rearward when torquing the two fasteners.
Check the Muffler Hanger and Strap
Check that the muffler can be moved both vertically and horizontally in the muffler hanger. The muffler should move in the muffler hanger a minimum
of 1.60 mm (1/16 in.) vertically (direction A) and 3 mm (1/8 in.) horizontally (direction B).
If the muffler does not move freely, perform the following procedure:
