SW1 L4-1.9L SOHC VIN 8 (1996)
12. Loosen installation bolt nut and remove installation bolt.
13. Install clutch drive plate holder tool SA951OAC.
14. Install center bolt and tighten.
Torque: 13 N.m (115 in-lbs)
IMPORTANT: After tightening the center bolt, check to make sure that the pulley rotates smoothly by spinning it.
15. Check to make sure clutch clearance is 0.5 mm-0.7 mm (0.018 in-0.030 in.).
16. If necessary, adjust clearance by adding shim(s) provided. Refer to steps 6 through 8 of Removal procedure to remove drive plate, then after
installing shim(s), refer to steps 8 through 15 to install drive plate.