SW1 L4-1.9L SOHC VIN 8 (1996)
48.
Install HVAC module lower trim panel.
49.
Install right and left console extension assemblies.
50.
Enable the SIR system. (Refer to "Enabling the SIR System" in the 1996 or 1997 "SIR Service Manual," depending on vehicle year.)
51.
Set radio station presets.
52.
Clear any SIR diagnostic trouble codes that may have set during delayed blower motor control module testing. (Refer to the 1996 or 1997 "SIR
Service Manual," depending on vehicle year.)
Wiring Splicing
With the wiring used in the Saturn vehicles, it is recommended that approved Packard Electric Crimp and Seal Splice Sleeves (or equivalent) be used.
1.
Remove insulation from both ends, recommended strip length is 9.5 mm (3/8 in.). Caution must be used to prevent cutting the wire strands.
Locate new splice a minimum of 40 mm (1-1/2 in.) from an outlet or other splice.
2.
Determine proper sleeve for gage of wire. Position stripped ends in sleeve until wires hit stop.
IMPORTANT:
When using the salmon splice sleeve with 0.35 sq.mm (22 gage) wire, remove 19 mm (3/4 in.) of insulation. Bend the stripped portion in half to
double the thickness of the wire going into the splice sleeve. Twist the stripped, doubled wire and insert into the splice sleeve.
IMPORTANT:
