SW1 L4-1.9L SOHC VIN 8 (1996)
11.
From passenger's side of vehicle:
11.1 Route delayed blower motor control module pigtail harness between forward edge of heater duct and carpet.
11.2 Attach delayed blower motor control module pigtail harness connector to the lower forward edge of the heater duct. Place clip as far forward
as possible.
12.
Using black electrical tape, solid wrap 381 mm (15 in.) of the delayed blower motor control module jumper harness, starting at electrical
connector end.
13.
Connect delayed blower motor control module jumper harness with delayed blower motor control module pigtail at heater duct.
14.
Route delayed blower motor control module jumper harness under front heater duct, forward of rear heater duct (if equipped), to the I/P wiring
harness on the driver's side of the vehicle.
