SW1 L4-1.9L SOHC VIN 8 (1996)
10.
Install hole plug (P/N 21121827).
11.
Properly dispose of disinfectant and rinse water runoff collected in drain pan into a sanitary drain.
12.
Remove protective covering from interior of vehicle.
IMPORTANT:
Before enabling afterblow function, refer to Customer Information in this bulletin and review operation of afterblow function with customer.
13.
If the delayed blower motor control module is to be installed, proceed to "Delayed Blower Motor Control Module Installation" in this bulletin.
Applying Cooling Coil Coating (P/N 12346390) to Evaporator
Perform this procedure only if you are using Cooling Coil Coating (P/N 12346390).
CAUTION:
COOLING COIL COATING CAN CAUSE TEMPORARY EYE INJURY. DO NOT GET COOLING COIL COATING IN EYES OR ON
CLOTHING. WASH THOROUGHLY WITH SOAP AND WATER AFTER HANDLING.
FIRST AID:
IF COOLING COIL COATING GETS INTO EYES, HOLD EYELIDS OPEN AND FLUSH WITH A STEADY, GENTLE STREAM OF WATER
FOR 15 MINUTES. OBTAIN MEDICAL ATTENTION IF IRRITATION PERSISTS.
1.
Allow vehicle to cool down before performing cooling coil coating procedure.
2.
Put on rubber gloves and safety glasses.
3.
Using cleaning gun, OTC Tool SA9216NE (or equivalent siphon-type parts cleaning spray gun capable of delivering 2 ounces per minute of liquid
with shop air at 552-620 kpa [80-90 psi]), insert siphon hose into container of cooling coil coating. Take care to place the bottle in a secure upright
position to avoid spilling contents.
4.
Regulate shop air to 276-414 kPa (40-60 psi).
