SW1 L4-1.9L SOHC VIN 8 (1996)
9.
Install hole plug (P/N 21121827).
10.
Properly dispose of cooling coil coating runoff collected in drain pan into a sanitary drain.
11.
Remove protective covering from interior of vehicle.
IMPORTANT:
Before enabling afterblow function, refer to Customer Information in this bulletin and review operation of afterblow function with customer.
12.
If the delayed blower motor control module is to be installed, proceed to "Delayed Blower Motor Control Module Installation" in this bulletin.
Delayed Blower Motor Control Module Installation
IMPORTANT:
Before proceeding with the installation of the delayed blower motor control module, make sure the customer is fully aware of its function and
operation.
The parts are required to install the delayed blower motor control module shown.
IMPORTANT:
On SL Sedans and SCi Coupes, check the underhood junction block (UHJB) for a 30A power convenience (PWR CONVCE) fuse. If there is no 30A
power convenience fuse, the underhood junction block must be replaced with a new underhood junction block P/N 21023711 for 1996 vehicles or
P/N 21021982 for 1997 vehicles. If there is a 30A power convenience fuse, the underhood junction block does not need to be replaced.
