SW1 L4-1.9L SOHC VIN 8 (1996)
Due to the addition of enhanced electronics on 2000 - 2002 Model Year Saturns, it is necessary to remove a fuse prior to flat-towing. This is to
prevent battery drain during extended towing times with key On.
1.
Position and attach the vehicle to be towed.
2.
Turn the ignition key to ACC position.
3.
Turn fog lamps and all accessories Off.
4.
Shift transaxle to N (Neutral).
5.
Open hood.
NOTICE:
When removing fuse, pull fuse straight up. Do not rock fuse from side to side or terminal damage may result.
6.
Open underhood fuse block (UHFB) cover and remove the IGN 1/4 30A maxifuse shown at location (1). (Refer to underside of the UHFB cover
for specific maxifuse location.)
7.
Replace UHFB cover.
8.
Close hood.
NOTICE:
When towing vehicle with all four wheels on the ground, make sure the towing speed does not exceed 65 mph (105 km/h) or your vehicle could be
severely damaged.
NOTICE:
Don't tow the vehicle with the front drive wheels on the ground if one of the front tires is the compact spare tire. Towing with two different tire sizes
on the front of the vehicle can cause severe damage to the transaxle.
NOTICE:
Too much or too little fluid can damage the transaxle. Be sure that the transaxle fluid is at the proper level before towing with all four wheels on the
ground.
UPON REACHING DESTINATION:
