SW1 L4-1.9L SOHC VIN 8 (1996)
IAC air plug installed for Minimum air adjustment
3. Insert the IAC air plug in the throttle body.
^
(Saturn Tool) SA9106E used for SOHC (L24)/DOHC (LLO)
4. Using Scan tool unit, check idle speed. If not within specifications (0 rpm [stall] to 700 rpm):
^
Inspect throttle blade for binding. Clean bore if necessary. Replace throttle body if throttle blade continues to bind after cleaning.
^
Inspect for vacuum leaks at vacuum hoses and gasket surfaces. Correct any vacuum leaks.
NOTE: Engine must be at normal operating temperature (upper radiator hose warm). Spark adaptive cells must be at "0."
5. If the minimum idle speed is above 700 rpm after performing the required repairs, replace the throttle body. Do not adjust minimum idle.
6. Using Scan tool unit, check voltage on TP sensor. Do not replace the sensor unless setting is outside of 0.35-0.70 volt limit.
7. Remove IAC air plug.
8. Start engine and check for proper idle operation.
9. Refer to Fuel System or Computer System diagnostic charts if concern is not corrected.
