SW1 L4-1.9L SOHC VIN 8 (1996)
Vehicle Speed Sensor: Service and Repair
Transaxle Turbine Shaft Speed Sensor
Assembly
REMOVAL
1. Position vehicle on lift and raise vehicle.
2. Disconnect electrical connector from turbine shaft speed sensor and remove sensor.
NOTE: Inspect O-ring for damage and replace if necessary.
INSTALLATION
1. Install turbine shaft speed sensor.
2. Install sensor.
- Torque: 26 N.m (19 ft-lbs)
NOTE: Clean and lubricate with Saturn Transaxle fluid. Wipe off excess fluid and install.
3. Connect electrical connector to sensor. Push in until a click is heard and pull back on connector to confirm positive engagement.
4. Lower vehicle.
5. Check transaxle fluid level.