SW1 L4-1.9L SOHC VIN 8 (1996)
7.
Route rubber purge line that goes between the EVAP canister purge solenoid assembly and the metal line at front of dash. Loop purge line as
shown in illustration to make sure it is positioned downwards.
8.
Connect EVAP caniser purge line from intake manifold to EVAP canister purge solenoid.
9.
Connect electrical connector. Push electrical connector until a click is heard, and then pull back on electrical connector to confirm a positive
engagement.
10.
Lower vehicle from hoist.
11.
Connect negative battery cable.
Torque: 17 N.m (13 ft-lbs)
PARTS REQUIREMENTS
21006689
Solenoid-EVAP Cnstr Purge
CLAIM INFORMATION
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System using the appropriate Electronic
Labor Time Guide and Labor Operation Code J6400 (Replace Evaporative Emission Canister Purge Solenoid).
